The cradle has been constructed out of special quality steel to give baby a soothing happy rocking motion when lying and playing, plus a place where baby can be fed or rest close to supervision without being held.
It has a sturdy pure cotton crochet cover that stands up to hard use and can be washed and replaced on the frame for quick drying. To remove or replace cover, simply compress the frame inwards from the sides. When replacing be sure that the hem is secure over the washer on each side of the frame.
The harness, which is made of strong cotton webbing, is interlocked and sewn into the cover, has no buckles or other device that can accidentally come undone. Easing the baby into the harness is simple if you apply pressure on the base frame while sliding baby gently into place.
The vertical height of the frame from the floor to top of the cradle should be no more than 350mm and pressure may be applied to the frame to adjust the height downwards should it be necessary. The frame has been built in two sections and can be dismantled if desired for storage or travel purposes. When reassembling ensure the top of the frame slides fully into the bottom frame.
Baby should not be left unattended particularly where there is any possibility that a fall may occur. It is strongly recommended that the product is used only on the floor. It is possible and likely that baby in its enjoyment of the cradle will be able to move about smooth surfaces, so make sure that baby is always well supervised and away from danger areas. Baby will usually be almost sitting before outgrowing the bouncer.
Vendor: Baby Bounce